Rokonet ORBiT-14 Manual de usuario descargar pdf (Pagina 23)

User's Manual

Group Arming

Group arming enables you to arm a number of zones using the key.

Ask your installer about defining groups.

STEP DESCRIPTION

Check the READY LED on your keypad. If it is lit or flashing, the

system is READY to be armed.

If it is NOT lit or flashing, the system is NOT ready to be armed. In

this case secure or bypass the violated zone(s) and then proceed.

Enter your 4-digit User Code followed by

NOTE:

If you make a mistake when entering your User Code, the keypad will

produce three short beeps. If so, re-enter the above sequence correctly.

Enter the group number. You have 4 options for group arming: 1,

2, 3 and 0. To arm all groups, use the “0”. For example, to arm

group 3 press:

4 The keypad will beep as it counts down the Exit Delay period.

NOTES:

Pressing + [Group Number] +

will silence the beeps on the keypad and

cancel the Entry Delay time.

Pressing + [Group Number] + during exit time will silence the beeps on

the keypad.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 41 42

Sin comentarios

Rokonet ORBiT-14 Manual de usuario Pagina 23