Rokonet Orbit-6 Manual de usuario descargar pdf (Pagina 29)

User Manual

Section 7: System Troubles

Your

ORBIT-6

is designed to report any

troubles

or malfunctions it may detect.

Notification that a problem exists is made to the user, through indications on

the keypad(s) and, in many cases, to the Central Station and to your dealer.

Any incidence of trouble should be taken seriously and acted upon

immediately. If not remedied quickly, a trouble condition will likely compromise

your system and prevent it from properly doing its job.

The ORBIT-6 is designed to be as trouble-free as possible. Were a problem to

develop, the

POWER

LED will flash about once every second. If so, to

determine the problem, perform the sequence on the following page.

In certain cases, the keypad's FIRE LED may remain lit steadily, even though

there is no alarm in progress and the system is disarmed. Refer to the

explanation and remedy below:

USER FUNCTION DESCRIPTION AND REMEDY

the FIRE LED

remains lit

After a fire alarm has occurred and been silenced, the

keypad's red FIRE LED will remain lit steadily if a Smoke

Detector (presumably the one which caused the alarm)

remains tripped. Until reset, a tripped Smoke Detector will

prevent the READY LED from being lit, and will NOT permit

the system to be armed.

To reset a tripped Smoke detector and to extinguish the red

FIRE LED, follow this procedure, which is typical:

+ USER CODE

64444744448

UTILITY OUTPUT NUMBER

(which is responsible for resetting the Smoke Detector)

Consult your security dealer for alternate information on

resetting smoke detectors, if applicable.

Once done, the READY LED will indicate the system's

status and you will be able to arm your system.

1 2 ... 24 25 26 27 28 29 30 31 32

Sin comentarios

Rokonet Orbit-6 Manual de usuario Pagina 29