Rokonet ORBiT-14 Manual de usuario descargar pdf (Pagina 28)

Installation and Programming Manual

C. Initial Programming:

8- Observe the Following and Perform these Initial Steps

a) After about 20 seconds, the keypad will produce either of the two displays below. Follow the instructions in the

column which is applicable to what is displayed:

If this display appears, follow the instructions in this

column:

If this display appears, follow the instructions in this

column:

b) press the [QQ] key; the keypad will display:

c) carefully enter the ORBIT-Pro’s default Installer

Code: [ 0 ] [ 2 ] [ 9 ] [ 6 ] (which will appear as

QQQQ) and press [ENTER]

d) the keypad briefly displays:

and then, this display:

b) Above, the term “PARTITION 1” represents the name

given to a previously-programmed ORBIT-Pro, or to

one of its partitions. Its appearance, rather than the

display at the upper left, indicates that this ORBIT-Pro

has:

• already been programmed

• protected the programmed configuration

• disabled your ability to restore the factory defaults

To enable your ability to restore the factory defaults,

follow the steps below:

c) press [QQ], then [7], then [1]

• note that the POWER LED will be flashing slowly,

indicating that the Programming Mode has been

entered

e) next, you must program the system to recognize the

keypad; to do so, press [7]; the display will show:

(Note: MDL=Module)

press the [ENTER] key; the keypad displays:

d) at this display:

• enter this ORBIT-Pro’s current Installer Code; note

that this must be the Installer Code assigned to this

panel when it was last in service

• if the ORBIT-Pro’s factory default Installer Code

was retained during the panel’s previous use, enter

[0] [2] [9] [6] (which will appear as QQQQQQQQ) and

press [ENTER]

f) press [ENTER] again; the display shows:

g)change the keypad’s TYPE to LCD by pressing the

[STAY] key until TYPE=LCD appears in the lower

right of the display

e) the keypad briefly displays:

and then, at this display:

press [ENTER], followed by [7]

PARTITION 1

--:-- ... .. ...

INSTALLER CODE:

ROKONET

Please Wait ...

PARTITION 1

--:-- ... .. ...

INSTALLATION:

PLEASE, WAIT

INSTALLER PROG:

1)SYSTEM ↓↓

INSTALLATION:

PLEASE, WAIT

INSTALLER PROG:

1)SYSTEM ↓↓

INSTALLER CODE:

ACCESSORIES:

1)ADD/DEL MDL ↓↓

ADD A MODULE:

1)KEYPAD ↓↓

KEYPADS:

ID=01 TYPE=NONE

To Install

Press QQ

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 69 70

Comentarios a estos manuales

Sin comentarios

Rokonet ORBiT-14 Manual de usuario Pagina 28

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Rokonet ORBiT-14