Rokonet ORBiT-14 Manual de usuario descargar pdf (Pagina 36)

Installation and Programming Manual

EXAMPLE 3: Adding A Zone Expansion Module

1- Press the [S] key until you are returned to your

previous selection in the “HOME” column.

2- Read this step first before pressing any keys.

To gain entry into Adding Expansion Modules

category, you can either press the DOWN-

arrow twice to access the following display,

and then press

[ENTER]

. If so, go directly to

Step 3…

You can skip this display and the need for

Pressing [ENTER] and go directly to Step 14 by

simply pressing the “Quick Key” [7].

3- At this display:

press [ENTER] to derive the next display.

4- Read this step first before pressing any keys.

To add a Zone Expansion Module, you

can either press the DOWN-arrow once to

access the following display,

and then press [ENTER]. If so, go directly to

Step 4…

you can skip this display and the need for

pressing [ENTER] and go directly to Step 16 by

simply pressing the “Quick Key” [2].

5- From this display:

press either the [STAY] or [ARM] key until

the proper Zone Expansion Module appears.

Choose among the following:

§ ZE08 (adds 8 Hardwired Zones)

§ ZE16 (adds 16 Hardwired Zones)

§ WZ08 (adds 8 Wireless Zones)

§ WZ16 (adds 16 Wireless Zones)

which, when installed, would have to be “DIP

switch” set with the physical I.D. of “1”.

When done, press the

[

]

key, as required, to

return to the “HOME” column.

7- Read this step first before pressing any keys.

You can Exit from Installer Programming by

using the DOWN-arrow key to scroll to this

display:

and pressing [ENTER]…

by pressing the “Quick Key” [0]. In either

case, the following display will appear:

8- At this point, you may either

§ press [ENTER] to save the changes you

made; they will be stored in the ORBIT-

Pro’s configuration until such time as they

should be modified or reset

§ for purposes of this tutorial, any changes

you made can be discarded by selecting

“N”, using either the [STAY] or [ARM] key,

followed by pressing [ENTER].

In either case, after a few moments, the

ORBIT-Pro will return to its normal (user)

display.

NOTE: The (00:01) in Step 4 of Example 1 is a factory device “address” and has no bearing on your programming.

Keypad Timeout

If, after 15 minutes, no entry is made to a keypad placed in the Installer Programming, it will produce an audible

reminder consisting of several beeps in rapid succession, along with this display:

Pressing any key will stop the beeps. To re-enter Installer Programming, you’ll have to key in your Installer Code,

and press [ENTER].

INSTALLER PROG:

5)DIALER ××

ACCESSORIES:

1)ADD/DEL MDL ↓↓

ZONE EXPANDER:

ID=1 TYPE=NONE

DO YOU WANT TO

SAVE THE DATA? Y

INSTALLER PROG:

7)ACCESSORIES ××

ADD A MODULE:

2)ZONE EXP. ××

ADD A MODULE:

1)KEYPAD ↓↓

INSTALLER PROG:

0)EXIT PROGRAM ↑↑

TIMEOUT

HIT ANY KEY

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 69 70

Comentarios a estos manuales

Sin comentarios

Rokonet ORBiT-14 Manual de usuario Pagina 36

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Rokonet ORBiT-14