Rokonet ORBiT-14 Manual de usuario descargar pdf (Pagina 60)

Installation and Programming Manual

ZONES: MAINTENANCE (cont’d)

Quick Key Item Explanation

2 9 7 Zone Self Test

(cont’d)

CHOOSING A TESTING SCHEDULE

§ in Installer Programming, locate:

1)SYSTEM / 1)TIME DEFINE / 7)ZONE TEST TIMES

i) when at this display, press [ENTER] to proceed:

ii) press [ENTER] again

iii) at this display, define the time (in 24-Hour format) when the

first test will begin; use the DOWN-arrow (BYP) and/or UP-

arrow (STAT), as required, to reposition the cursor

iv) press [ENTER]

v) press the DOWN-arrow once to obtain this display:

vi) and press [ENTER]

vii) enter the desired interval separating each test (between

01 and 24 hours) and press [ENTER]

viii) press the [SS] key to exit

SETTING UP THE UTILITY OUTPUT TO TRIGGER THE NOISE

SOURCE

§ for background information on Utility Outputs, refer to page 1-4

at the top level of Installer Programming, refer to 3)UTIL

OUTPUT

i) from this display:

ii) press [ENTER]

iii) choose a Utility Output to trigger the noise source (see page 3-

41), by selecting an unused UO number (e.g. UO2);

press [ENTER]

iv) at this display, press [1] to select SYSTEM

TIME DEFINE:

7)Z.TEST TIMES ××

START TEST AT:

HOUR:00 MIN:00

ZONE TEST TIMES

1)START TST AT:↓↓

ZONE TEST TIMES

2)Z.TEST PERIOD↑↑

ZONE TEST PERIOD

PERIOD:10(00-24)

INSTALLER PROG:

3)UTIL OUTPUT ××

SELECT UO NUMBER

UO=01 (0:1)

UO=02 FOLLOWS:

0)NOTHING ↓↓

INSTALLER PROG:

2)ZONES ↓↓

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 69 70

Comentarios a estos manuales

Sin comentarios

Rokonet ORBiT-14 Manual de usuario Pagina 60

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Rokonet ORBiT-14