Rokonet ORBiT-14 Manual de usuario descargar pdf (Pagina 29)

Installation and Programming Manual

h) press the [ENTER] key; the resulting display confirms

the following information about the keypad:

• it has been given the I.D. of “01” (which matches

the keypad’s DIP switch settings

• it has been assigned to Partition 1 (the only

partition in the system, thus far)

f) at this display:

press the [STAY] key once so that the display reads:

and then press [ENTER]

g) remove the J2 DEFAULT jumper from its position on

the Main Board, and place it over one of the two pins

for safekeeping

h) press [QQ] and then [0]; the keypad displays

i) save this information by pressing the [QQ] key four

times, followed by [0]; the keypad will then display:

j) press [ENTER] to confirm; the display shows:

and then, a few moments later:

i) press [ENTER]; the display shows:

and then, a few moments later:

k) after a moment, the system will enter its ordinary

operating mode

j) when the ORBIT-Pro’s factory defaults have been

restored, this display will appear

§ until the system’s TIME and DATE are set, the display will show hyphens and periods, respectively

§ “PARTITION 1” is the default designation given to the system at this time; during programming, it can be

changed to give the installation a name (e.g. “The Jones’s”, “Elm Lumber”) in a non-partitioned system, or to

identify a specific area (e.g. “Sales Dept”) in a partitioned system

9- Choose Among the Following Options:

to end your initial

programming session now:

to wall-mount your keypad and

continue programming

to continue programming

• remove power (both AC and

Standby Battery) from your system

until you’re ready to continue with

Installer Programming

• the ORBIT-Pro will retain its

programmed data

• when ready, proceed with Installer

Programming below

• remove power (both AC

and Standby Battery) to avoid a

tamper alarm

• locate the keypad’s tamper

“plunger” and orient its slot

vertically

• if desired, re-apply power after

mounting the keypad; the above

display will appear after a few

seconds

• when ready, continue with

Installer Programming below

• continue below

DEFAULT EN/DIS:

DEFAULT DISABLE

DEFAULT EN/DIS:

DEFAULT ENABLE

DO YOU WANT TO

SAVE THE DATA? Y

PLEASE, WAIT

DATA SAVING..

DATA IS SAVED

PLEASE WAIT ...

PARTITION 1

--:-- ... .. ...

ASSIGN TO PAR:

KEYP=01 PAR= 1

DO YOU WANT TO

SAVE THE DATA? Y

DEFAULT ENABLE

PLEASE, WAIT

DATA SAVING..

DATA IS SAVED

PLEASE WAIT ...

PARTITION 1

--:-- ... .. ...

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 69 70

Comentarios a estos manuales

Sin comentarios

Rokonet ORBiT-14 Manual de usuario Pagina 29

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Rokonet ORBiT-14